Hilti 3444489 Manual de Utilização e Manutenção

DCH 300Operating instructions enMode d’emploi frManual de instrucciones esManual de instruções pt

3. Accessories, consumablesDCH 300 ABR disc mount 212259, Reversible flangeØ80 mm, clamping flangeØ80 mm, clamping nut M16 x 1.5Depth gauge for the DC

5. Safety instructions5.1 General power tool safety warningsWARNING! Read all safety warnings and all instruc-tions. Failure to follow the warnings an

or storing power tools. Such preventive safetymeasures reduce the risk of starting the powertool accidentally.d) Store idle power tools out of the rea

k) Position the cord clear of the spinning accessory.If you lose control, the cord may be cut or snaggedand your hand or arm may be pulled into thespi

the wheel in the cut and the possibility of kickbackor wheel breakage.b) Do not position your body in line with and behindthe rotating wheel. When the

on your skin may promote absorption of harmfulchemicals.5.3.3 Power tool use and carea) Cutting discs must be stored, handled and fittedcarefully in a

5.3.6 Personal protective equipmentThe user and any other persons in the vicinity mustwear ANSI Z87.1‐approved eye protection, a hardhat, ear protecti

GG2. Move the cutting depth sliding indicator to thedesired cutting depth.6.3 Fitting a cutting discDANGERUse only the metric‐size clamping flange and

8. Check to ensure that the spindle lockbutton hasdisengaged.6.4 Removing the cutting disc from the toolTo remove the cutting disc from the tool, foll

7.2.1 Unlocking the power tool1. Plug the supply cord into the power outlet. Theyellow theft protection indicator LED blinks. Thepower tool is then re

1This Product is CertifiedCe produit est homologuéProducto homologado porEste produto está registradoCUS

8. Care and maintenanceCAUTIONDisconnect the supply cord plug from the poweroutlet.8.1 Care of the power toolDANGERWhen working on metal under extreme

Fault Possible cause RemedyThe power tool doesn’t start.The power tool has not beenunlocked (tools with optional theftprotection system).Use the TPS k

11. Manufacturer’s warrantyHilti warrants that the tool supplied is free of defectsin material and workmanship. This warranty is validso long as the t

en18

*212019*212019Hilti CorporationLI-9494 SchaanTel.:+423/2342111Fax: +423/2342965www.hilti.comHilti = registered trademark of Hilti Corp., Schaan W 34

23

213"#"“"]"["Ç4

5

DCH 300 Diamond cutterIt is essential that the operating instructionsare read before the machine is operated forthe first time.Always keep these opera

CAUTIONDraws attention to a potentially dangerous situationthat could lead to slight personal injury or damage tothe equipment or other property.NOTED

The working environment may be as follows: construction site, workshop, renovation, conversion or newconstruction.To avoid the risk of injury, use onl

2.9 Using extension cordsUse only extension cords of a type approved for the application and with conductors of adequate gauge. Thepower tool may othe